Introduction

Difficulty Very Easy Steps 3 Time Required  5 minutes

These instructions cover how to open the Nano SeaCam and remove the camera chassis. 

Step 1 Remove Endcap Snap Ring

	Use a tool such as a 2mm flat blade screwdriver to pry out the end of helical snap ring that retains the endcap
	Using a plastic pry tool or spudger, run the tool around the snap ring to pry up the remainder.  A plastic tool ensures that no metal shavings or dust enter the housing or contaminate the seals

Step 2 Pull Endcap Out from Housing

Using firm pressure, pull the housing and endcap apart slightly to break the seal.  The endcap is quite short, so if you find it difficult to grip, consider using a dummy plug or test whip with a locking sleeve to add extra gripping space to the endcap.

Step 3 Remove Camera Chassis

	Gently tip the open end of the housing into your hand and let the camera chassis fall out.
	Stuff a lint free wipe or cover the housing's opening with parafilm to prevent any dust from entering.

Next Steps