How to Remove and Replace the microSD Card in the IP model HD Multi SeaCam

Difficulty Very Easy Steps 4 Time Required < 5 minutes

This guide explains how to remove and replace the microSD card in the IP model HD Multi SeaCam

Step 1 Remove Snap Chassis from Endcap

	Using a sharpie or similar marker/pen, make a mark on the chassis sleeve at the keying pin to allow for easy alignment when closing
	Using firm pressure, grip the chassis and pop it off of the end cap. Do not pull too hard as this can tug at the wiring causing wear and damage

Step 2 Remove the microSD Card

Step 3 Installing the microSD Card

	Format the microSD card as VFAT(32-bit) before installing into the camera WARNING: Do not attempt to use the web-based user interface to format microSD cards larger than 32GB in size. Larger microSD cards must be preformatted before installation. Use fdisk on a Linux operating system or a 3rd party Windows partition management utility.
	Using the tweezers, gently grip the microSD card and place it in the memory card slot as shown
	Using the plastic pry tool, press down on the microSD card to engage the memory card latch and secure card in the camera

Step 4 Reattach the Snap Chassis to the Endcap

Replace the desiccant pack if removed earlier Align the keying pin in the endcap with the marked slot on the snap chassis Gently press the snap chassis into the endcap Be sure not to pinch any wires

Previous Step                                   Next Step